Loading and Unloading
 
 
First Select the proper Ammunition 7.63x25 or the calibre for your particular model and load the ammunition onto a stripper clip. Insure the weapon is not loaded The bolt will remain open if there are no cartridges left in the weapon..
 If not already done,Retract the bolt, WHILE POINTING THE GUN IN A SAFE DIRECTION, Insert the stripper clip and push downward on the top round until all rounds are fed into the magazine. Remove the stripper clip. The bolt will drive foreward chambering the first round. REMEMBER:THE GUN IS THEN READY TO FIRE WHEN THE STRIPPER CLIP IS WITHDRAWN!!
ALTERNATIVE METHOD OF LOADING#1:  
Remove the Magazine Floorplate, Follower Spring and Follower. Deposit the desired number of cartridges. Re-install the follower,follower spring and magazine floorplate. Retract and release the bolt. THE GUN IS THEN READY TO FIRE!!
ALTERNATIVE METHOD OF LOADING#2:  
Manufacture a bolt hold open tool the dimentions are as follows:  
1.33cm(.525") x 2.5mm(.1") x 5cm(2")  
Make the tool of DELRIN or ThermoForm plastic.  
You then retract the bolt and insert the bolt hold open in the stripper clip slot. Cartridges are then inserted 1 by 1 until the desired amount is reached. When ready extract the hold open tool.  
REMEMBER:THE GUN IS THEN READY TO FIRE WHEN THE HOLD OPEN TOOL IS WITHDRAWN!!
METHOD OF UNLOADING#1:  
To unload the weapon simply cycle the bolt by hand until the last cartridge is ejected
METHOD OF UNLOADING#2:  
Remove the magazine floorplate,follower spring, and follower. Dump out cartridges. Cycle bolt by hand to eject any possible rounds in the chamber.
Email: joeyd@northwest-denture.com